Strong wood counter tops are natural products product of wooden from trees roughly one hundred twenty years old. Wood is a living material and the more moisture receives, the extra the wood countertop will expand. The wood we used in solid wood worktops has been previously kiln dried to a humidity degree of 6%, and it is therefore important that the worktop is not uncovered to a consistently excessive stage of humidity. Normally the humidity degree in kitchens is approximately 50-70%.
The solid wood high have to be hooked up to the cabinet box using solely wood screws and washers. It isn’t advisable at all to glue the highest on the cabinet box; the top and the field expand and contract at different rates, subsequently cracks would possibly ultimately seem, most likely on the cabinets’ surface.
The right means of putting in a strong wood top is utilizing metal fixings alongside the cabinet field (see our net page).
The metal fixings should be uniformly distributed throughout the length of the highest, spaced at a 1′ – 1.5′ distance from every other. Across the width, the top is usually mounted to each metal assist with three screws, one in the middle, one towards the front edge and one towards the rear edge. The supports have to be perfectly leveled; in any other case tensions can develop within the wooden, resulting in warping, cupping, or cracks.
We suggest pre-drilling the screw holes into the wooden countertop, so as to avoid cracks and splits. For the same purpose, it’s a good suggestion to not over tighten the screws. The finishing will considerably diminish the extent of such movements, but will not eliminate them altogether. Because of the panel’s laminated construction, the lengthwise movements are insignificant, so the installer should pay attention to the actions occurring throughout the panel’s width. With a purpose to prevent the development of inside tensions, the holes in the steel fixings should be elongated in the route of the movements (see our web web page ).
When uncovered to regular humidity ranges – i.e. 50-60% – the worktop’s width will expand by 1/12″-1/24″, but when exposed to a level of 80-90%, this measurement might develop by as much as half” or much more for some species. Due to this fact, when the rear fringe of the counter top is installed against a wall, the wall may limit the highest’s pure movements, leading to undesired tensions within the wood. To keep away from this, you’ll be able to permit a 1/4″-1/2″ joint between the wall and the countertop edge and caulk it with a skinny bid of acid-free silicone.
Additionally, you’ll be able to firmly repair the rear edge to the metallic supports underneath and thus, enable the natural movements to happen at the expense of the other edge. On this case, the holes in the metal fixings akin to the rear edge will likely be no larger than the screws diameter, whereas the holes equivalent to the middle section and the front edge shall be elongated.
Go To Kitchen Cabinet Suppliers To View Cool Kitchen Storage Cabinet , Kitchen Cabinet Handles